Sears Garage Door Opener Light Does Not Work

Why the light stays on.

Sears garage door opener light does not work.

The first thing you want to check is the socket your craftsman opener is connected to. The repair guide and video show how to replace a garage door opener rpm sensor in 6 steps. To know for sure what the problem is you may want to have a service technician check the garage door opener. Then within 30 seconds hold the button on your remote for three seconds or until garage door opener s lights flash or the led light on your opener blinks.

So get a ladder and place it under the opener. If the garage door opener is not powered up it won t work. To reprogram your garage door remote locate then press your opener s learn button. If your chain drive garage door opener s led light flashes 5 times and the door moves just a few inches at a time the rpm sensor might be the problem.

Bulbs will not work in older garage door openers and some people believe these new style bulbs can actually interfere with the transmitter and receiver causing the opener remotes to not work properly. Unplug the garage door opener then immediately plug the opener back into the electrical outlet. Listen for the light relay on the logic board to click. If not remove the bell wire from the opener terminal screws.

More and more products are being produced at a faster rate and that leads to reduced quality. The light will come on any time someone walks in front of the beams. Unplug the garage door opener from the socket outlet and plug in another device. If the opener runs check for a faulty wire connection at the wall control a short under the staples or a broken w ire.

This is to verify if the socket works. Most openers come with motion sensors. Short the red and white terminals by touching both terminals at the same time with a piece of wire. In some garage door opener systems the transformer on the cf bulbs will cause interference with the receiver on the logic control board.

If your model works properly when using those cf bulbs then you should be able to continue using them. If you hear a click replace the light socket if you do not hear a click replace the logic board. The next thing to check is your home s circuit breaker or fuse. Motion sensors were triggered.

If the wall control doesn t light up and work properly then the wall control or the logic board in the garage door opener is defective. Light bulb needs to be replaced in garage door opener. We have observed brand new light bulbs that don t work right out of the box. Diagnosing this type of wall control is more complicated than the single led type.

Try using your remote to open or close your door to determine if the reprogramming was successful.